Are you tired of flying small, sensible cameras that aren't trying to break your neck or bank account? Do you want to jump a camera whose manufacturer SPECIFICALLY STATES is NOT meant to be used as an action camera... bec, what do they know?? Well, you can now take this beast of a camera on your next skydiving/BASE/paragliding adventure, so you can capture all of the gnar with unparalled image quality...
 
The Insta360 One RS 1-INCH LoProMoFo was purpose-built to house this camera during your bad decisions...featuring ultimate  ease of use and convenience, with durability at the forefront of the design and material choices. All of this is acheived whilst minimizing snag-points on your aerial adventure.
 
The snag-free, semi-flexible housing provides a super snug, protective glove around your camera, while still allowing FULL ACCESS to ALL buttons, screens, displays, and status indicator lights.* The LoProMoFo's base follows the EXACT contour of your helmet's curves for maximum and secure adhesion via VBH tape, becoming one unit with your helmet, without the need to drill any holes.

Of course, the camera housing can also be completely removed from helmet / base for travel or hitting the wind tunnel by removing the two screws at base with the included hex key...leaving a snag-free base that's ready to fly without worries. Camera angle / tilt adjustment can easily be achieved by slightly loosening the recessed stainless steel screws at the base with included  key,  then re-tightening screws so that they are once again snug. 
 
Warning: Insta360's own product description states that the "ONE RS 1-inch 360 is NOT intended for extreme action scenarios.  If you're looking for a more rugged, waterproof, and action-friendly 360 camera, try our Insta360 X3!"  This camera is heavy, and the much larger lenses protruding further away from your head's center of mass significantly increases the forces your cervical spine will experience in all high speed scenarios. It is YOUR responsibility to READ and understand the fine print in our Terms and Conditions page, and in our included product brochure. You will be using this product understanding that it is NOT meant to be used in high speed envirotnment (skydiving/ BASE / paragliding), and if you do, you do so at your own risk. If you are even considering this as your first camera to use in your skydiving / BASE adventures, you're a dumbass and you should look elsewhere to make your bad decisions.
 
Cage or Sleeve....which do I want? The SLEEVE variant is recommended for this camera because it offers reduced helmet drag when jumping with the camara inside the housing, and significantly reduced clearance AND drag when the camera is NOT inside the housing. The cage variant is only being offered because inevitably there will be those who will not trust that their camera can be kept safe without the need to completely wrap around the camera. As with ALL other Adrenaline Workshop camera mounts, NOTHING extra is needed to keep that camera in place, with either version. That means no bands, straps, bungees, thoughts, or prayers are needed... simply place the camera completely inside the housing, and you're ready to rage.
 
For those who want to be able to swap between different cameras on the same helmet, or want to completely do away with the need to screw/unscrew the housing from the base for travel / tunnel flying, you may want to check out the RapidRelease Helmet Base, noting all of the labeled components.  Select RapidRelease CAMERA Base from the Helmet / Mounting Surface drop-down menu for THIS product (so that your LoProMoFo Camera housing comes with the necessary RapidRelease CAMERA Base to make the whole system work), and also purchase the corresponding RapidRelease Helmet Base for your specific helmet.
 
If you don't see your helmet / size listed in the drop down menu, please contact us prior to ordering so we can ensure the proper fit for your new camera mount on your specific helmet!
 
* In order to maximize the structural integrity of the camera housing, the USB-C charging port is NOT accessible with the camera inside the housing. However, the camera can be removed from the housing with minimal effort for this purpose without needing to screw/unscrew anything.